Snow Performance SNOW Stg III Boost Cooler Kits Water Meth Kits - SNO-310

The Snow Performance Stage 3 Boost Cooler® brings true 2D mapped water-methanol injection delivery to your EFI (electronic fuel injected) and forced induction (turbocharged/supercharged) vehicle. The Stage 3 creates a 2D injection map based off boost and fuel injector pulse width to deliver a extremely accurate amount of water-methanol when the engine needs it most. Bringing fuel injector pulse width into the mix allows the injection curve to be extended past specific boost points for greater range/control. None invasive, the Stage 3 Boost Cooler® controller is designed to mount on the steering column or the dash so no additional gauge pods need to be purchased and functions as a boost gauge, water-meth controller and fuel system monitor all in one! Proven to reduce the air inlet temperature by up to 100 degrees and increase octane by 25 points for maximum HP and cooling . Comes with adjustable Stage 3 water-meth controller, 1/4" High Temp Nylon line and easy to install quick-connect fittings.

Stage 3 Boost Cooler™ EFI 2D MAP Progressive Water-Methanol Injection Kit (Red High Temp Nylon, Quick-Connect Fittings)

Stage 3 Boost Cooler™ EFI 2D MAP Progressive Water-Methanol Injection Kit

Snow Performance Stage 3 EFI 2D Map Progressive Water Injection Kit

Cleans all carbon build up out of your motor

Reduce air intake temps out too 100 degrees

Water / Methanol Injection System

Two-dimensional injection map

Meth Inject System - SNO-310

Increase octane by 25 points

Built in boost gauge

Meth Inject System

New nozzle design

Lower EGTS